BuildersPlanet.comBuildersPlanet Home Page
Marketplace Job Bank Buy/Sell Community News Services
 HOME  >  Job Bank >  The Quiz  >  Quiz Part 1 Instant Feedback

TAKE THE QUIZ!

So you think your a well rounded tradesman huh?
This is an actual test that a remodeling contractor used to screen new employees.
Only one person ever aced it and got 100%
Boyd Nelson of Los Osos, California.
Take the test and you'll get the results back in seconds

There are   4  parts with 13 questions each.
Part 1   :   Part2   :   Part3   :   Part4   :   All 51   :   Get the next 13 questions  

Come on give it a try! Your one smart cookie Sorry try again.

Submit A Question

1. What does GFCI stand for?
Generator Fault Circuit Indicator
Ground Fault Circuit Interupter
Ground Field Circuit Incedence
Gone Fishing Can't Interupt
2. What does a GFCI do when it is "in action"?
Connect a circuit
Prevent circuit testing
Allow circuit testing
Turn off a circuit
3. What is Romex?
Wire
Strapping
Insulation
Flooring
4. What gauge(s) is a typical extension cord?
8 to 12
16 to 20
4 to 8
12 to 16
5. In a typical light circuit?
The white wires are tied together and the black wires are switched
The black wires are tied together and the white wires are switched
The ground wires are tied together and the white wires are switched
The white wires are tied together and the ground wires are switched
6. A typical new residential main electrical panel is what size?
75 to 100amps
300 to 400 amps
150 to 200 amps
250 to 300 amps
7. In typical new residential approximately how many standard (100 watt+/-) lights can go on one 15 amp circuit?
eight
twelve
twenty
two
8. In typical new residential how many standard outlets can go on one 20 amp circuit?
six
twelve
twenty
three
9. What are the two most common guages of wire in new residential construction?
#12 and #14
#16 and #18
#6 and #8
#10 and #18
10. "Fixture units" refers to
How many toilets you have
Fixture value for sizing pipes
Number of Light fixtures
Number of plumbing fixtures
11. Gas line pressure between the meter and the structure is
high and from the meter to the street it is low.
high and from the meter to the street it is high.
low and from the meter to the street it is low.
low and from the meter to the street it is high.
12.A "rule" used for determining if a layout,wall or floor is 'square' or 90 degrees is?
3, 4, 5 rule
'Franklins' Rule
4, 8, 10 rule
49rs rule
13. When soldering copper water line you should first heat the
fitting
solder
pipe
coffee

       Get the next 13 questions.

Submit A Question


Home|Marketplace|Buy Sell|Job Bank|Community|News|Service|Contact Us

?998- 2008 BuildersPlanet All rights reserved
By using this site you accept our terms  and privacy policy.
For comments or problems, email Webmaster@buildersplanet.comSears Promo Code